IMER MASONRY 600 Manual De Uso, Mantenimiento Y Recambios página 16

14.4 Changing the disc
To change the disc refer to the "Disc assembly" paragraph.
15 MAINTENANCE
- Maintenance must be done by suitably trained
personnel, after switching off the electric motor, and
disconnecting the power plug.
- Check the condition of the power cable before
starting to use the machine: someone may have
inadvertently damaged it.
- Make sure the guards/safety equipment are always
functional and in good condition.
Do not leave the machine outdoors: it must be protected from
weather.
The cleaning operations to be carried out at the end of each
work shift are indicated below.
15.1 Tank cleaning
Empty the tank, removing the cap. Remove the cutting deposit
formed using a jet of water.
15.2 Reference tables cleaning
The support tables must be kept clean. Deposits of dirt can
adversely affect the precision of cutting.
15.3 Runners cleaning
It is advisable to remove any trace of dirt that may have
formed on the runners.
15.4 Cleaning and maintenance of the cooling system
If no water is reaching the blade, stop cutting immediately to
avoid damaging the blade.
Stop the machine and check that there is sufficient water in the
tank.
If necessary, unplug the machine and check that the pump tap,
hose or filter is not blocked.
16 Repairs
- All maintenance operations must be performed
exclusively with the machine switched off, and with the
power plug disconnected from the mains.
- If any guards are removed for repairs, ensure they
are correctly refitted at the end of work.
Use exclusively original IMER spare parts; modifications to
parts are strictly prohibited.
17 RESIDUAL RISKS AND SAFETY NOTICES
Although the saw has been manufactured in full compliance
with current regulations, residual risks exist that cannot be
eliminated and which require the use of appropriate personal
protection equipment. The machine is equipped with notices to
indicate the residual risks and how to avoid them.
IMER INTERNATIONAL S.p.A
NOISE HAZARD
HAND CRUSHING/SHEARING HAZARD
EYE INJURY HAZARD
INCORRECT USE HAZARD
TRAPPING/CRUSHING AND SHEARING HAZARD
ELECTROCUTION HAZARD
Note that the employer is responsible for ensuring his workers
use personal protective equipment.
16
Wear ear defenders
Wear gloves
Wear safety glasses
Read the manual before operating the
machine
Cutting with water is compulsory
Do not remove the guards
Danger of cutting
Danger - electrical power