Publicidad
Step 4A - Tension Installation
• NOTE: The rod should be installed with the set screws (F) on the bottom side and the curve facing out of the tub.
• PERSON 1: While facing the tub hold the left mounting bracket (A) and firmly press against the left wall.
• PERSON 2: Hold the right mounting bracket (B) and firmly press against the right wall.
RECOMMEND
Step 4B - Tension Installation
• NOTE: Make sure the rod is level and adjust if needed.
• PERSON 2: Secure the length of the rod by fully tightening the screws (F) with the allen wrench (E).
A
RECOMMEND
Step 5 - Tension Installation
• Twist the adjuster so the rod tightens firmly against the wall.
• After tightening the rod fully, insert the set screw cap (G) into the screws on the underside of rod.
RECOMMEND
5
PUSH
PERSON 1
(LEFT)
E
G
PUSH
PERSON 2
(RIGHT)
B
1-800-892-3986
TO P B
B
PU SH AG AI
NS T
F LO OR
TO P B
B
PU SH AG AI
NS T
F LO OR
IS19172-I2
Publicidad
