Assembly - Home Depot HD18481302BPS Guia De Inicio Rapido

Assembly

Step 1: Post Assembly
i. The top post section has a plastic endcap on one end and
the bottom post has a foot leveler attached. Threaded post
jointers are pre-installed for your convenience. Screw the posts
(1 long & short) tightly together. (See Diagram #1)
Diagram #1
Step 3: Additional Shelves Assembly (See Diagram #4)
i. Locate the desired position of the next lowest shelf and
insert the tapered sleeves into the posts.
ii. Slide the shelf down from the top of the posts and onto
the tapered sleeves. Push down on each shelf corner, ensuring
that the shelf is in the fully locked position.
iii. Repeat for the remaining shelves.
Diagram #4
Step 4: Adjust the foot levelers in or out at the bottom of the
posts to attain proper leveling. (See Diagram #5)
Diagram #5
Step 2: Bottom Shelf Assembly
i. Locate the desired position of the bottom shelf.
ii. Insert four plastic tapered sleeves into the appropriate post groove,
one in each post. Ensure tapered end is up. See arrow on lock.
(See Diagram #2)
iii. Place shelf on its side and slide each post with tapered sleeves
through the bottom of the shelf until snug. (See Diagram #3)
iv. After all posts are in place, position the unit in the upright position.
v. Push down on each corner of the shelf, ensuring that the shelf is
in the fully locked position.
TOP
Diagram #2
double line marking
Note: the tapered sleeves must be at the same height for each pole to ensure
the shelf sit on the sleeves levelly.
Note: the post has groove with double line marking. it can help to identify the
height of tapered sleeve in each post.
3
Please contact 888-449-5520 for further assistance.
Diagram #3
UPSIDE (level side)
HOMEDEPOT.COM
up
NSF
HDX
down