Sylvania SQCM480ST-38CDC Manual De Instrucciones página 6

SELF REPAIR SET
Touch-up repair paint
1. Paint directly on the mantel unit if necessary. fig. A
If any problems are found with the original parts during mantel assembly such as
the panels cannot be installed with the plastic connector. Try to solve by one of the
following method.
Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
Pencil, Hammer, Philips Screwdrivers, Safety Goggles and gloves (if necessary).
WARNING: WEAR GOGGLES WHEN USING POWER TOOLS.
Option 1: Use the spare KD NUTS, KDSCREWS and PLASTIC CONNECTOR
1. Place the PLASTIC CONNECTOR on the mantel unit and mark the drill-holes as
shown in fig. B.
All manuals and user guides at all-guides.com
fig. A
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm) on
the mantel. Each Plastic Connector needs 3 holes. See fig. C.
3. Gently install the KD NUTS into the drilled-holes with hammer as shown in fig. D.
4. Attach the PLASTIC CONNECTOR and lock in place with KD SCREWS as shown in
fig. E.
Option 2: Use the SMALL L-BRACKETS and SCREWS
1. Place the SMALL L-BRACKET to the unit as shown and mark the drill-holes on the
mantel as shown in fig. F.
fig. B
fig. C
fig. D
fig. E