Remington STYLIST TURBO 2200 Manual Del Usuario página 6

ENGLISH
THE HAIRDRYER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN
NOT IN USE.
Do not leave the dryer unattended when switched on.
Allow the dryer to cool down before storage.
Do not immerse in water or other liquids.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
Damaged cords can be dangerous.
In use, take care that the inlet and outlet grilles are not blocked in any way as this will
cause the unit to automatically stop. Should this occur, switch off and allow the unit to
cool down.
Ensure the inlet grille is free from obstructions such as household fluff, loose hair etc.
Do not place hairdryer on soft material e.g. carpet, bedding, towels, rugs etc.
Do not leave the dryer switched on when you set it down.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Do not direct the airflow towards the eyes or other sensitive areas.
Do not use any attachments with this hairdryer, other than those supplied by
Remington
Avoid allowing any part of the hairdryer to contact the face, neck or scalp.
This appliance is not intended for commercial or salon use.
If the supply cord of this unit becomes damaged, discontinue use immediately and
return the appliance to your nearest authorised Remington
replacement in order to avoid a hazard.
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other item(s),
caused by misuse, abuse or non-compliance with these instructions.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their safety should give explicit
instructions or supervise the use of the appliance.
This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult
a qualified electrician.
110448_REM_IFU_D3710_21L.indd GB_3
®
.
WIRING INSTRUCTIONS UK PLUGS ONLY
®
service dealer for repair or
3
24.06.11 16:07