Grupo Urrea SURTEK RH405 Guia De Inicio Rapido página 4

DRAWING ASSEMBLY
TROUBLESHOOTING FOR THE
HEAD OF THE RIVER GUN
3
1. Make sure that there is no air
flow going to the rivet gun.
2. Use spanner to remove the
head form the frame (fig.1)
fig.1
3. Use the spanner to remove the
Jaw Housing. Jaws, Jaw Pusher
and the Pusher Spring. (fig.2)
fig.2
4. Throughly clean the inside of
the Frame Head. (fig.3)
fig.3
5. Use light gauge machine oil to
lubricate the parts shown in fig.4.
fig.4
6. Re-assemble the Rivet Gun
and check the lenght of the Rivet
Gun Head by using the spanner
as shown in fig.5.
fig.5
No. Description
1A 3/16" Nosepiece
1B 5/32" Nosepiece
1C 1/8" Nosepiece
1D 3/32" Nosepiece
06-1 Jaw Case Front Tart
3/32", 1/8", 5/32"
06-2 Jaw Case End Tart
07 Jaw
08 Jaw Pusher
09 Case Washer Ring
10 Jaw Pusher Spring
10A Frame Cap O Ring 27x 2
11 Frame head
12 Case Lock Nut
13 Back Up Ring
14 Back Up O Ring p12
15 Frame
16 Oil Piston
17 Oil Piston O Ring p2A
18 Back Up Ring
19 Return Spring
20 Hanging Clip
21 Frame Cap
22 Frame Cap Nut
23 Safety Cap
24 Setting Screw Pin
25 Back Up O Ring 12
26 Back Up Ring
No. Description
27 Frame Lock Nut
28 Rubber Cushion
29 Air Cylinder
30-1 Air Piston Stem
Air Piston Al
30-2
30-3 Air Piston Lock Nut
30-4 Big Iron Plate
30-5 Small Iron Plate
31A Air Piston Ring
32 Cylinder O Ring 67,94x2,62
33 Cylinder Cap
35 Spanner Gauge
36 Spanner
Trigger Pin
37
38 Connector
39 Trigger Rod
40 Trigger
41 Connector
42 Trigger Lever
43 Lever Pin
43A Valve Pusher O Ring
44 Valve Pusher
Valve Spring
44A
45 Valve
45A Valve Collar
45B Collar O Ring p5
46 Valve Spirng
51 Valve Cap O Rng p11
52 Valve Cap