1byone O00QH-0507 Manual De Instrucciones página 5

after 30 seconds, then re-pair the wanted PIR
EN
sensor.
DE
5. Installation:
FR
For the receiver, plug in the receiver into any safe
ES
power outlet.
For the PIR sensor, it can be mounted on a wall or
IT
just put it on a flat place.
To mount on the wall:
Drill holes on the wall. Next push the wall plug into
the drilled holes, and then insert the screw into
the wall plugs. Finally, mount the PIR sensor on the
screw.
Notes:
・The recommended installation height for the
PIR sensor is 3.3-4.9ft (1.0-1.5m ).
・The PIR sensor detecting angle is 45 degree and
detecting distance is16.4-26.2ft (5-8m). Install
the PIR sensor in key monitoring areas such as
the entrance to a garage, store, or house.
・If installing the PIR sensor outside, note that
moving leaves and branches, strong wind, and
drastic changes in temperature can affect and
influence the sensor.
- 07 -
・The PIR sensor and receiver can connect up to
300ft/100m without any obstacles.
・The PIR sensor's transmitting frequency is
433MHz and its range can be affected by metal,
walls, concretes, and interfering signals from
other electronic appliances with the same
frequency, including televisions, radios, and
cookers.
・Avoid placing the PIR sensor and receiver near
to the above mentioned electronic appliances.
・Do not expose the PIR sensor and receiver to
direct sunlight or high temperatures, otherwise
overheating may cause them irreparably
damaged.
・Do not install the PIR sensor and receiver near
any source of naked flames such as lighted
candles.
・Please test the PIR sensor and receiver at the
potential installation locations before actual
installation to confirm range and transmission
effectiveness.
・The receiver will reset all parings after cut off
the power supply, you need to re-pair your PIR
sensors when you want to use them again.
- 08 -
EN
DE
FR
ES
IT