Jamie Oliver Home 4s Manual Del Usuario página 14

INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your barbecue and causing injury to yourself and to
property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with the regulator.
4. Turn all of the control knobs to the 'O' position before turning on the gas supply to the barbecue.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR BARBECUE
Lighting Instructions: Main Burners
1. Open the lid before lighting.
2. Connect the gas cylinder to the barbecue following the instructions supplied with the regulator.
3. Turn all the control knobs to the 'O' position.
4. Turn ON the gas supply at the cylinder or regulator switch following the regulator connection and operating instructions.
Check the cylinder to regulator connection and hose to barbecue hose inlet connection for leakage using soapy
water. Any leakage will show as bubbles in the area of the leak. If a leak is found, do not use the barbecue. Consult
your gas or barbecue supplier for advice.
5. To light the left hand burner, push down and turn the left burner control knob anti-clockwise to the 90° position (full
rate position). An audible click will be heard, this should light the burner. Check that the burner is alight. If the burner
has not lit, repeat this process.
6. If the burner has not lit after two attempts, turn OFF the gas tap and wait 5 minutes before retrying the ignition sequence.
7. When the burner has lit, the burner rate can be adjusted by pushing down and turning the knob anti-clockwise to any
position between the full and low rate position.
8. Light the remaining burners from left to right in sequence.
9. To turn OFF the barbecue, turn the cylinder valve handle or regulator switch to the 'O' position by following the
regulator instructions. Once the burners have extinguished turn all the control knobs to the 'O' position.
10. Turn OFF the gas supply at the cylinder or regulator switch.
Warning: If any burner fails to ignite, turn the control knob to the 'O' position (clockwise) and also turn
the cylinder valve off. Wait five minutes before attempting to relight.
Side burner lighting instructions (
1. Once the grill burner has been lit, the side burner can be lit by following the instructions below.
2. Open the side burner lid before lighting the side burner and turn the side burner control knob to the 'O' position.
3. Push down the side burner control knob and keep pressing whilst turning anti-clockwise to the full rate position, an
audible click will be heard, this will light the burner. If the burner does not light, repeat this process.
4. If the burner has not lit after two attempts, turn OFF the gas tap, wait 5 minutes and then repeat step 3 in main burner
lighting instructions.
5. When the burner has lit, the burner rate can be adjusted by pushing down and turning the knob anti-clockwise to any
position between the full and low rate position.
6. To turn the barbecue side burner off, turn the cylinder valve or regulator switch to the 'O' position and then turn all of
the control knobs on the barbecue clockwise to the 'O' position untill the flames have been extinguished
Warning: If the burner fails to ignite, turn the control knob to the 'O' position (clockwise) and also turn the cylinder valve
off. Wait five minutes before attempting to relight with ignition sequence.
If applicable)
:
14
041215