Zodi 1060 Manual De Instrucciones

INSTRUCTION MANUAL
SET-UP
Attach hose end to pump. Open battery case lid and load 4 new
1.
D Cell alkaline batteries into portable battery case. Securely
close the lid and lock the battery case latch making sure that
the rubber gasket is in place. Check pump operation by holding
pump in hand while pushing red ON/OFF button on battery case.
You should be able to feel and hear pump spinning. If pump
fails to operate, open battery case lid, gently bend tabs out,
check that batteries are installed correctly and close lid again.
Pump will not be harmed by operating out of water. Do not use
old batteries or mix old and new batteries. Do not mix alkaline,
carbon-zinc, or rechargeable batteries.
Before use, squeeze any kinks from hoses.
2.
Completely submerge pump in water source (e.g.,
For showers:
in a bucket or lake). Shake pump under water to release any
trapped air. Do not submerge battery case in water.
Place pump in the lowest part of the boat and
Bilge Pump:
position output end of hose over the side of the boat. Pump is
a recreational grade back-up only and should not be used as
primary bilge or relied upon in life-saving situations. For best
bilge performance, remove showerhead from hose.
Push the red ON/OFF button on battery case to establish water
3.
flow from showerhead. Water should be flowing from output hose
within 20 seconds, if not, apply suction to the end of the hose to
release vapor lock. DO NOT place the pump directly on sandy river
or lake beds. Place the pump on top of pebbles or rocks. To prevent
waves from pushing pump onto shore, place a small rock on hose
near pump, making sure water flow isn't constricted. If water flow
is low, replace batteries or clean debris screen by unscrewing cap
on pump.
ZODI UPGRADES
™
Zodi™ Shower Pole
Enjoy hands-free showering.
Adjustable height. Works
with all Zodi™ Showers and
Zodi™ Hut shower shelter.
Item# 1068
800-589-2849
1060 Portable Battery Powered Sump Pump
1061 Portable Battery Powered Bilge Pump
1066 Portable Battery Powered Shower
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
SHOWERING
Turn pump on. Water will begin spraying from showerhead. Conserve
water by placing showerhead in water bucket between uses or turn
off water flow by turning off pump. To turn off pump, push red button
on battery case. See www.zodi.com for Instant Hot Shower Heater.
SHUT DOWN
Turn power off on battery case. Drain water from hoses and
showerhead. After use, unscrew pump cap, clean foam debris
screen and rinse pump in clean water. Remove batteries before
long term storage.
TECH SUPPORT
If you are having a problem with your Zodi™ Battery Powered
Portable Pump please do not return it to the store. First, replace
the batteries with new ones, making sure tabs inside battery
case are bent outward to make good contact with top and bottom
of batteries.
If pump is still not operational, call Zodi™ at 800-589-2849.
Most problems can be corrected over the phone.
Pump must always be submerged when operating. Do
CAUTION:
not mix old and new batteries. Do not mix alkaline, carbon-zinc, or
rechargeable batteries.
These directions apply to both the Zodi™ Battery Powered
Note:
Shower and the Zodi™ Battery Powered Bilge Pump.
Hot Tap™ Shower
Our best selling
on-demand water
heater and hot shower.
Enjoy unlimited hot
water in seconds.
Item# 6185
Assembled in China. Designed in Park City Utah USA.
i.HUT™
Enjoy this self-supporting
privacy shelter anywhere.
Almost 4 feet wide per
side. Includes oversized
detachable floor.
Item# 1077
zodi.com