TOW READY 118149 Instrucciones De Instalación

Please read all instructions carefully before assembly, installation and/or use of this product.
WARNING:
DO NOT DRILL INTO THE RECEIVER'S CROSS TUBE, USE PLASTIC CABLE TIES INCLUDED OR EQUIVALENT.
Contents:
mounting
openings
C
Screw (2)
E
Cable ties
Vertical mounting option
(requires 1 cable tie)
118149 UNIVERSAL 4- FLAT MOUNTING BRACKET
INSTALLATION INSTRUCTIONS
Upper Housing
A
4-Way Flat Connector,
Not included &
shown for reference only
Bottom
Housing
D
Set Screw (1)
Fig.1
Horizontal mounting option
(requires 2 cable ties)
Fig.2
Assembly instructions:
STEP 1
•
Locate the vehicle's trailer wiring harness with 4-way flat receptacle
"F".
•
Install Dust Cover (if equipped, sold separately) over the connector
body as shown on picture.
F
STEP 2
•
Position part "F" into the top portion of Upper Housing "A" such
that the wires are separated as shown. Check to see that connector
body is fully inserted.
STEP 3
•
Position and lock Bottom Housing "B" into the place. Make sure
that connector "F" is positioned properly and housing's locking tabs
are fully engaged.
STEP 4
•
Insert two screws provided and secure two housings using phillips
screwdriver # 2.
•
Adjust set screw "D" if connector body is still loose inside the
housing. Do not over tighten the set screw.
STEP 5
•
Thread the cable ties through the openings provided in the
mounting bracket as shown for vertical or horizontal orientation. For
vertical orientation keep dust cover on the top as show on the
picture. Tighten the cable tie(s) "E" over the tubing to secure the
bracket.
B
Step 1
Step 5
(refer to Fig.2)
Step 2 Step 3
Step 4
D
©2010 Cequent Performance Products, Inc.
47774 Anchor Court West
Plymouth, MI 48170
118149N Rev B 5-12-10
Printed in XXXXX