Troubleshooting - Zeegma Sap Pro Manual Del Usuario

ҋ If you use various ingredients to make juice, it is advisable to mix their order.
EN
ҋ
If one of juice ingredients is leaves, insert them into the device along
with other fruit to maintain squeezing capability.
ҋ
Be careful when juicing hard fruits and vegetables (e.g. carrots). The
device may overheat earlier.

Troubleshooting

Problem
Squeezer stops during
operation.
Juice contains pulp
or juice comes out of
pulp outlet.
Motor is too loud or
vibrates.
Tank contains pulp
and juice takes on
a color.
Salad accessories (fig. 11)
1. Push rod
2. Cover
3. Knife
4. Tank
Check
Has the power cord plug
been inserted properly?
Has force been used to
insert fruits/vegetables in
the squeezer?
Haven't you inserted too
many fruits/vegetables?
Has the device been
operating for more than 20
minutes?
Has the rubber seal been
properly installed?
Is the device standing on
a flat surface?
Have all pieces of the set
been properly assembled?
Tanks and accessories may
take on colors when you use
products with pigment (e.g.
carrot, spinach, etc.).
Solution
Insert the plug into the socket.
Remove some fruits/vegetables,
press „R" (reverse switch), wait for
about 2-3 seconds, if the squeezer
does not unblock, repeat the
procedure. If the machine still fails
to operate, clean the machine.
Follow the steps above.
Leave the squeezer for about 10
minutes to let it cool down, start
again if necessary.
Apply or correct the rubber seal as
described in the manual.
Place the squeezer on a flat surface.
If the product has been properly
assembled, overripe fruits/vegetables
may have been used – it is not
surprising that the product is louder.
Clean the device shortly after use.
5. Mandrel
6. Motor
7. Base