Mx Onda MX-HD2424 Manual De Instrucciones página 86

5. Slide the lock button on the water outlet 8 to
the ON position and the water or the solution
introduced in the reservoir 2, will begin to exit
through the tip.
6. During cleaning, you can increase or
decrease the water flow pressure by means
of control 3, or turn the tip by means of the
rotation ring of tip 6 to direct the water jet
towards the desired zone.
7. When you need to stop the water coming
out, to remove the tip from the mouth to
rinse, rest, etc. Slide the locking button of the
water outlet 8 to the OFF position. Never
remove the tip from the mouth if you have
not turned off the irrigator before or stopped
the water flow by pressing button 8.
8. When cleaning is complete, slide the water
outlet lock button 8 to the OFF position,
remove the mouthpiece from the mouth, and
then turn the appliance off by turning control
3 clockwise until a "click" is heard.
9. Unplug the irrigator from the mains socket, remove reservoir 2 and
empty it in the sink.
10. Replace the reservoir 2 in the base, point the tip towards the sink
and turn on the irrigator by turning control 3 to the right, this will
empty the pump and the flexible tube. When the water stops
flowing, turn the appliance off again by turning control 3 to the left
until you hear a "click".
11. When emptying the pump and the flexible tube, it will prevent the
formation of bacteria inside the pump and the flexible tube due to
the accumulated water.
12. Place the handle in its holder, taking care that the self-coiling tube is
correctly lodged in its housing and that it is not bent or forced.
13. Remove the tip and store it in the compartment located on the
reservoir lid and 9. Unplug the irrigator from the mains socket.
11