TRUSST Goal Post Guía De Referencia Rápida página 4

Goal Post Kit QRG
Instructions
1. Lay the sections of the Goal Post Kit on a flat, horizontal surface in
the shape of an inverted 'U'.
2. Arrange the sections so that the numbers on the ends will match
when you connect the truss sections together.
3. Join the sections together and secure them with either the double
sided conical connector or the quick-release pins provided.
(See Image)
4. Tap the steel spigots into place where the conical connectors are
used, using a hammer, using care not to strike the aluminum truss.
5. Install the cotter pins in the holes located on the ends of the spigots to
retain them in place.
6. Install the base plates into the ends of the assembled Arch Kit.
(1 and 7)
7. Secure the base plates into the truss Goal Post Kit using the provided
spigots. Tap the steel spigots into place using a hammer, using care
not to strike the aluminum truss.
8. Install the cotter pins in the holes located on the ends of the spigots to
retain them in place.
9. Carefully lift the assembled Goal Post Kit to an upright position,
using two persons if necessary.
10. Reverse steps 1-9 to disassemble the Goal Post Kit.
Use care not to strike the aluminum truss. Permanent damage may occur.
Wear protective safety gear when assembling this product. Loud banging
may damage hearing.
Prior familiarization of the Goal Post Kit construction will greatly reduce
assembly time and difficulties during a show setup or breakdown.
4
EN