Timer Set Up; Cleaning And Maintenance; Technical Data - camry Premium CR 4223 Manual De Uso

18. During mixing of hot products exercise extreme caution to avoid burning.
19. The device has been designed to prepare small amounts of food products. The device is
not intended for industrial food processing.
DESCRIPTION OF THE DEVICE (figures 1 and 2 and 3)
1.Top of food processor
4. Base
7. LCD time display
10. Plus button
A – Dough hook
BEFORE USING MULTIFUNCTION FOOD PROCESSOR
Before assembling the device, be sure the power cord unplugged from the power outlet and the speed selector (6) is on the "0" position.
1.Press the tilt button (2), the top of the mixer (1) will automatically release and lock into the tilt position.
2.Select the desired attachment, which is depending on the mixture to be performed:
A - hook for kneading the dough,
B - mixing beater for mixing and beating eggs and butter,
C - egg whisk for beating and frothing the egg white / cream / liquid food.
3.Insert the desired attachment directly, until it lock into correct position – see figures 4 and 5.
Note: Ensure the attachment is fully inserted into the socket, otherwise your mixing result may be affected.
4.Place the bowl (3) on the base (4), then turn the bowl (3) in clockwise until it locks.
5.To lower the top of food processor (1), press the tilt button (2) and push by one hand the top of food processor (1) down. A click sound will
be heard when the part has reached the correct position. Make sure the bow cover (5) is fixed in place (see figure 1).
USING
1. Ensure that the speed selector (6) is at the OFF position, then insert the plug in the power source.
2. Turn the speed selector (6) to your desired speed setting from "0" that means OFF position till "6" means the fastest speed. The motor
rotation speed number will be shown at LCD speed display (8).
3. The time display (7) will show the time elapsed since the device was switched on until now
It is a case, the timer is not set up, timer is counting up time from start (0:00) to switch off moment.

TIMER SET UP

To set up the timer that is counting operation period from switch on to desired moment in time and next switch off the devise automatically,
follow up below steps:
•Press the timer button (9), the LCD time display (7) shows 00:30 – half minute.
•Press repeatedly the plus button (10) to enlarge the operation time at intervals of 30 seconds.
•Press repeatedly the minus button (11) to reduce the operation time at intervals of 30 seconds.
•After selecting the desired period of operation the LCD time display (7) will flashing 3 times to remember your setting. Next the time display
(7) will count down the operation time to 00:00. Motor will be stopped automatically, the LCD time display (7) will flashing: 00:00, the LCD
speed display (8) will show speed zero.
4.To reach instantaneous maximum motor speed hold the speed selector (6) on position "P" – pulse.
To mix the food by suitable attachment follow up below brief instruction:
Attachment A: suitable for speeds 1-2. Time of operation: at speed 1: 30 seconds, at speed 2: 5-6 minutes.
Attachment B: suitable for speeds 1-4. Time of operation: at 1-2 speeds: 1 minute and at speeds 3-4: 3-4 minutes.
Attachment C: suitable for speeds 5-6. Time of operation: 5-7 minutes. To whip the egg whites, use a minimum of 3 eggs, and maximum of
15 egg whites.
Warning: Do not put knife, metal spoons, fork, spatula and so on into the bowl when it is operating.
5.The max operation time in one cycle shall not exceed 7 minutes. 10 minutes minimum rest time must be maintained between 2
consecutive cycles. After 2 consecutive cycles let the unit rest by 40 minutes.
6.When mixing is completed, turn the speed selector to "0" position, unplug the cord from power outlet.
7.Hold down the tilt button (2), the top of the mixer (1) will automatically lift and lock into the tilt position.
8.If necessary, you can scrape the excess food from an attachment by plastic spatula (D).
9.Pull out the mixing attachment with a little force by turning to the left side and then down. The speed selector must be at "0" position and
the power outlet must be unplugged before pulling out the mixing attachment.
The food processor will automatically switch off after the locked-rotor motor stop working for 15 seconds. The device can't continually work
for a long time, if work more than 2 cycles by 7 minutes, please wait for 40 minutes before the next mixing.

CLEANING AND MAINTENANCE

1.Unplug the device from the power and let it cools down before cleaning.
2.Remove the accessories before cleaning them in water with washing-up liquid. Do not wash in dishwashers.
3.Wipe the external parts with kitchen towel or soft cloth.
4.Do not use abrasive materials to clean the device.
5.Don't immerse the base in water or other liquids.

TECHNICAL DATA

Power supply: 220-240V ~50Hz
Power: 1300W Max Power: 2000W
Stainless steel bowl 5 liters
Max operation time in 1 cycle: 7 min
Min rest time between cycle: 10 min
2. Tilt button
5.Bowl cover
8. LCD speed display
11. Minus button
B – Mixing beater
3.Bowl 5,0 liters
6. Speed selector
9. Timer button
C – Egg whisk
To protect your environment: please separate
carton boxes and plastic bags and dispose them in
corresponding waste bins. Used appliance should
be delivered to the dedicated collecting points due
to hazarsous components, which may effect the
environment. Do not dispose this appliance in the
common waste bin.
4
D - Spatula