Tabla de contenido
Publicidad
Installation
*Green – Reverse function:
If you connect a rear-view-camera to AV2 input you should connect
this wire to your rear light switch (positive 12V). In this case the
monitor automatically switches to AV2 when driving backward and
you can see the picture of the rear view camera.
Operation
Power
Press this button to switch on the unit.
To switch off the unit, press this button again.
Menu
Press this button to show OSD (On Screen display) and continue
pressing this button to select function. Press + and – buttons to
adjust the settings as desired.
Mode
With the mode button you can choose from pre-settings.
GROUND ZERO
Yellow wire V1
Yellow wire V2
Audio
Audio
Red – Connected to positive
12V power supply
Black – Wire to ground
Green – Reverse function*
4
Bright
Contrast
Color
Color density of picture
Tint
Mode
Rotation
Mirror function (image rotation)
IR Out
Audio channel A / B setting
Source Select
Video source select AV1 / AV2
Reset
Reset Brightness / Contrast / Color / Tint
Trouble shooting guide
Problem
No picture on display
Dark brightness
GROUND ZERO
Brightness of picture
Contrast of picture
Tint of picture
16:9 / 4:3 setting
Solution
*Press the power button on the
set or remote controller.
*Make sure the power source is
connected properly.
*Make sure the video code is
connected properly.
*Make sure the power of the
video source is ON.
*Adjust the picture bright
condition you want by pressing
MENU button.
5
Publicidad
Capítulos
Tabla de contenido
