Intellinet Network Solutions 560641 Instrucciones página 2

PoE Desktop Gigabit Switch
CONNECTIONS & INDICATORS
LEDs
The LED indicators make it easier to
monitor the switch and its connections.
Ports
All ports on the switch support Auto-MDI/
MDI-X functionality, so crossover cables
and uplink ports are not needed for
connections to PCs, routers, other switches,
etc. Cat5/5e/6 UTP/STP cables provide
optimal performance; if a status LED doesn't
indicate a link, check the corresponding
device for proper setup and operation.
Power
Use the included power cord to connect the device to an AC outlet.
Confirm that the power LED on the front panel is lit.
PLACEMENT
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface that can support the weight of the switch
• with a minimum of 25 mm (approx. 1") of clearance on
the top and sides for adequate ventilation
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.
• where it cannot be affected by excessive moisture
Chassis Ground Column (Rear Panel)
Wire the grounding terminal to an earth-grounding object to prevent power spikes.
Rackmount
The switch includes brackets and screws
for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side
of the switch and secure it in place with screws.
3. Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw
the brackets to the rack.
5. Reconnect any cables.
2
English
LED Color Status
On
PWR Green
Off
On
Link/
Green Blinking
Act
Off
On
PoE Yellow
Off
Instructions
Operation
Power on
Power off
Valid port connection
Sending or
receiving data
No link established
The connected device
is receiving power
No PSE/PoE
device is linked
&
2 3
4