Installation
1
Remove short bolts (Da), long
bolts (Db) and washers from the table
top and table legs
Attach the metal leg (B) to the table top (A) by using two short
bolts (Da), through two washers, through the table leg (B) and
into the table top (A).
Do not tighten completely.
Repeat procedure for the other three legs.
B
A
3
Tightening all the bolts
Turn table upright, then tighten all bolts by diagonal pattern.
Carefully adjust leg levelers to compensate for uneven ground.
Your table is now ready for use.
Da
A
B
2
Attaching the metal center ring
to the table leg
Attach the metal center ring (C) to the table legs (B) by using a long
bolts (Db) through a washer, through metal center ring (C) and into
table leg (B).
Do not tighten completely.
Repeat procedure for the other three legs.
4
Please contact 1-855-HD-HAMPTON for further assistance.
B
Db
C
HAMPTONBAY.COM
B
C