Flex WL 2800 18.0 Instrucciones De Funcionamiento Originales página 12

To attach/detach battery pack
(See figure C)
To attach the battery pack:
Align the raised rib on the battery pack with
the grooves in the tool, and then slide the
battery pack onto the tool.
NOTICE: When placing the battery pack
onto the tool, be sure that the raised rib
on the battery pack aligns with the groove
inside the tool and that the latches snap into
place properly. Improper attachment of the
battery pack can cause damage to internal
components.
To detach the battery pack:
Depress the battery-release button located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool.
Mounting the flood light to a
tripod (not included) (See figure D)
Choose a suitable tripod with 1/4-20 thread
screw, thread the screw into the tripod
mounting hole on the flood light.
WARNING!
Ensure the flood light is securely mounted on
your tripod. Unsecured flood light may fall resulting
in personal injuries and/or property damage.
Removable belt clip (See figure E)
Your tool is equipped with a removable belt
clip that can be positioned on the two sides
of the tool for convenient transport.
Install the belt clip onto the tool:
– Remove the battery pack from the tool.
– Align the rib and the hole of the belt clip
with the opening and the threaded hole on
the base of the tool.
– Insert the screw and securely tighten the
screw with a screwdriver (not included).
Remove the belt clip from the tool:
– Remove the battery pack from the tool.
– Use a screwdriver (not included) to loosen
the screw that attaches the belt clip to the
flood light.
– Remove the screw and the belt clip.
12
Integral Hook (See figure F)
Your tool is equipped with a hanging hook. It
can be carried or hung on a hook or a hook-
like object. To prevent the risk of injury or
product damage make sure that the hook is
sturdy enough to hold the weight of the light
with attached battery pack.
Adjusting the light head (See
figure G)
The light head pivots 200° for maximum
flexibility. Manually move the head to any
position within the pivot range. Do not force
the head beyond that range.
Connecting with vehicle power
source (See figure H)
The flood light can connect to a 12 Volt
vehicle power source, such as a cigarette
lighter receptacle or automotive power port.
Insert the plug of the charging adapter into
the port on the base of the light.
Connect the other end of the charging
adapter to the 12 Volt vehicle power source.
NOTICE: If the adapter does not fit firmly
into the cigarette lighter receptacle or
automotive power port, the receptacle may
not be suitable for use with the light. A poor
connection at the base of the adapter could
lead to electrical problems in the vehicle
outside of the protections offered by the
vehicle or light's fuse.
Switching on and off (see figure I)
Your light is equipped with a brightness
adjustment, providing different light
intensities for your operation.
Press the ON/OFF switch to turn on the light
in the maximum brightness stage.
Press the ON/OFF switch again to change to
the minimum brightness stage.
Press the third time to turn the light off.
Press and hold the ON/OFF switch for 3s to
turn on the red light. The red light serves as a
warning in emergencies or can be used when
hunting. Press the ON/OFF switch again to
return to the previous state.
WL 2800 18.0