Earlex WS125 Manual De Instrucciones página 13

WS125 / WS77
Operation
•
Remove filler cap and fill unit with clean water to the MAX level line indicator. Replace
cap (Fig. 1+2).
•
Screw hose onto threaded outlets of boiler and steamplate, securely by hand.
DO NOT overtighten
•
Connect supply cord from unit to power socket-outlet and switch on (Fig. 5).
When connecting the cordset to the unit, make sure the flap is fully open and
i
does not prevent the plug being fully inserted. Refer to diagram below.
If the flap touches the ribs on the cordset it may prevent the cordset inserting
fully into the unit.
Flap
•
lt can take up to 15 mins (approx.) before steam is produced - depending on fill water
quantity and temperature (Fig. 7).
•
DO NOT
leave unattended and keep children and pets out of the room.
•
Just before full steam production a small amount of bubbling and water will occur at
the steamplate.
•
BEWARE
of hot water discharge prior to steam emission.
•
Hold the steamplate flat against the wallpaper for approx. 10 seconds - from which
the paper should now easily come away using a wallpaper scraper (Fig. 9).
•
Some papers may need more steam than others. Operate steamer until water level is
low, then unplug unit and allow to cool for at least 2 minutes (Fig. 11).
CAUTION! WARNING
Danger of scalding.
droplets. Steam should not be directed towards electrical appliances.
Danger of scalding appears on the cap as either symbol.
Beware of steam
When finished, allow to cool completely and empty unit. Always store
unit empty.
CAUTION!
Before loosening the filler cap always allow the unit to cool
down for at least 2 minutes. Risk of scalding! Heated water can
leak from the steamplate during the heating-up phase. Hot water
can drip during overhead work.
(Fig. 3+4). Check regularly during use to ensure secure fit.
: Hot liquid or steam can burn.
Steam may also condense into boiling
- before removing the filler cap and refilling unit.
Flap
Cordset
EN
Flap
Cordset
13