Publicidad
6
LEDs
WPS/Power
Best
Better
Good
Front Panel
7
Deploy
Troubleshooting
Power, Hardware Connections, and LEDs
- Make sure the WRE2206 is plugged into an appropriate power source.
- Make sure the power source is turned on.
- Check the hardware connections
WRE2206 Access and Login
- Make sure you are using the correct IP address.
• The default IP address is 192.168.1.2.
• If you changed the IP address, use the new IP address.
- Check the hardware connections, and make sure the LEDs are behaving as expected.
- Make sure your Internet browser does not block pop-up windows and has JavaScript and Java enabled.
- Make sure your computer is in the same subnet as the WRE2206.
Resetting the WRE2206 to Its Factory Defaults
- If you reset the WRE2206, you lose all of the changes you have made. The WRE2206 re-loads its default settings, and the
username/password resets to admin/1234. You have to make all of your changes again.
If there are network connections problems, move the WRE2206 closer to the AP.
See the User's Guide for more troubleshooting and for how to use the ZyXEL WRE2206 broadband repeater.
EU Importer: ZyXEL Communication A/S | Generatorvej 8D, 2860 Søborg, Denmark | http://www.zyxel.dk
2/2
US Importer: ZyXEL Communications, Inc | 1130 North Miller Street Anaheim, CA92806-2001 | http://www.us.zyxel.com
1~4
5~9
≥10
= 50 - 100%
3 LED
= 25 - 50%
2 LED
< 25%
1 LED
AP
Best
Better
Good
Signal Strength
Move closer to AP
1~4
5~9
≥10
Number of Clients Indicator
1 LED Client numbers: 10 or more than 10
Client numbers: 5 to 9
2 LED
3 LED
Client numbers: 1 to 4
The LEDs are off. Client numbers: 0
Copyright © 2016 ZyXEL Communications Corp. All Rights Reserved
Publicidad
