Special Instructions - Continental CP-SA015 Manual De Usuario

· Always place the product on a at, level, stable, heat and stain-resistant surface.
· Do not allow the Power Cord to hang (e.g., over the edge of a table or counter) where it may be
tripped over or pulled.

SPECIAL INSTRUCTIONS:

A short power supply cord is provided to reduce the risk resulting from becoming entangled in or
tripping over a longer cord. Extension cords are available and may be used if care is exercised in their
use. If an extension cord is used:
- The marked electrical rating of the extension cord must be at least as great as that of the
product;
- Arrange the longer cord so that it will not drape over a countertop or tabletop where it
can be tripped over, snagged, or pulled on unintentionally (especially by children).
WARNING: This product is equipped with a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to t in a polarized outlet only one way. If the
plug does not t fully in the outlet, reverse the plug. If it still does not t, contact a quali ed
electrician. Do not modify the plug in any way.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
CAUTION: Use only scented or fragranced jar candles in clear, glass jars. Do not use frosted, cracked,
or damaged jar candles, and do not place bare, plastic, votive, tea light, or pillar candles on the
product.
NOTE: This Candle Warmer is designed to let the wax in the glass jar melt slowly, allowing the
fragrance to be released continuously. Using a jar candle larger than 3 inches wide and 2¾ inches high
is not recommended.
1. Plug the Power Cord into a standard 120-volt AC outlet.
2. Remove any attached lid from the jar candle, and then place the jar candle onto the Warming Plate.
3. To turn on, slide the Power Switch to the "ON" position. The Power Indicator will illuminate
indicating that the heating element is on.
CAUTION: Do not touch the Warming Plate, jar, or wax while the product is in use as they will be hot.
4. To turn o , slide the Power Switch to the "OFF" position, and then unplug the Power Cord from the
electrical outlet.
FOR HOUSEHOLD USE ONLY TO USE
On/Off Switch
Heating Plate
Control Panel
USB Cover