Royal Sovereign International RDH-130 Manual Del Usuario página 13

TROUBleSHOOTInG
1.Be sure the power cord is plugged into a working electrical outlet.
2.Check your room humidity level on display setting. The unit may simply be off because the humidity setting equals room humidity level.
3.Check for any obstructions.
Trouble
The unit does not work.
Water light is lit.
The air in the room is still humid.
Relative humidity setting not being reached after
a long period of operation.
On the Display (ES, AS, E1, P1 or P2)
All manuals and user guides at all-guides.com
Cause
1. No power supply.
2. Unit is not turned on.
3. Humidity is set higher than the room humidity.
4. The power was shut off and automatically turned back on.
1. There is blockage of the flow of water in the unit.
2. The bucket is full of water.
1. Air filter is dirty and or blocked.
2. The room temperature is below 5 °C (41 °F).
3. Poor air circulation or obstructions.
4. Humidity is set higher than the room humidity.
1. There are windows or doors opened.
2. Area is too large for the capacity of the dehumidifier.
These are error codes and protection codes
13
RDH-130/ 150/ 170
Solution
1. Plug power cord firmly into outlet and check fuse for that room.
2. Turn the unit on.
3. Set the humidity level on a lower percentage.
4. If a unit was turned off and turned on automatically the
compressor will take 5 minutes to start.
1. Check the hose for crimps or blockage.
2. Make sure the water is emptied
1. Clean the filter.
2. Raise the room temperature.
3. Improve the airflow by moving unit away from anything that
obstructs the airflow.
4. Set the humidity percentage to a lower percentage.
1. Check to see the windows and doors are closed.
2. Change the location of the dehumidifier with-in room.
See the CONTROL PANEL section.