Technical Data; Switching On And Off - BAUKER NLL01 Manual De Instrucciones

Technical Data

Laser Spirit Level
Power
Working time
Laser wave length
Laser power
Laser line width
Laser line dia.
Working range
Laser accuracy
Leveling accuracy
Working temperature
Dimensions (length x width x height)
Assembly
Inserting/Replacing the Batteries
Alkali-manganese batteries are recommended for the measuring
tool.
To open the battery lid 10 , slide it in the direction of the arrow away
from the battery compartment.Insert the batteries provided.When
inserting,pay attention to the correct polarity according to the repre-
sentation on the inside of the battery compartment.
Always replace all batteries at the same time. Only use batteries
from one brand and with the identical capacity.
NLL01
3V,2-AAA Battery
＞15h
Line:635nm/point:650nm
Class 2,＜1mw
100 LUX,3mm/3m
100 LUX,15mm/20m
Line:3m,Point:20m
Line:1mm/m,Point:0.5mm/m
1mm/m
0-40℃
161.4x21x33.8mm
LASER SPIRIT LEVEL
Remove the batteries from the measuring tool when not using it for extend-
ed periods. When storing for extended periods, the batteries can corrode
and self-discharge.
Operation
Initial Operation
Protect the measuring tool against moisture and direct sun light.
Do not subject the measuring tool to extreme temperatures or variations in
temperature. As an example, do not leave it in vehicles for longer periods.
In case of large variations in temperature, allow the measuring tool to
adjust to the ambient temperature before putting it into operation.
Avoid heavy impact to or falling down of the measuring tool. Damage to the
measuring tool can impair its accuracy.
Switch the measuring tool off during transport. When switching off, the
levelling unit, which can be damaged in case of intense movement, is
locked.

Switching On and Off

To switch on the measuring tool in line operation, push the On/Off
switch 1 forward . To switch on the measuring tool in point operation,
push the On/Off switch 1 back.
Immediately after switching on, the measuring tool sends a laser
beam out of outlet opening 5 (line operation) or 6(point operation),
depending on the selected operating mode.