Simer 2909-B Manual Del Usuario página 3

General Information / Installation
DESCRIPTION
These cords come with a 3-prong grounding
type power plug.
SPECIFICATIONS
Power Supply Required..................115V, 60 HZ
Cord Length:
Model 2909-B ........................................8 ft.
Model 2911-B ......................................25 ft.
INSTALLATION
Refer to Figure 1.
1. Disconnect power before servicing.
Hazardous voltage. Can
shock, burn or cause death. Before removing
a pump for service, always disconnect the
electrical power.
2. Loosen and remove the pump handle screws
and the pump handle.
3. Firmly but gently, pull up on the cord con-
nector to remove it from the cord connector
socket in the pump cover.
4. Plug the new cord connector into the pump
cover.
WARNING
Risk of electrical shock.
Can burn or kill.
Do not lift pump by
power cord.
1. Attempting to lift or support pump by power cord can damage cord and cord connections.
2. Cord may pull apart, exposing bare wires with possibility of fire or electrical shock.
3. Lifting or supporting pump by power cord will void warranty.
4. Use lifting ring or handle on top of pump for all lifting/lowering of pump. Disconnect
power to pump before doing any work on pump or attempting to remove pump from
sump.
For parts or assistance, call Simer Customer Service at
NOTICE: Be sure to align the three small
prongs in the pump cover cord connector
socket with the three small holes in the bot-
tom of the cord connector. See inset drawing
of Figure 1.
5. Reinstall the new pump handle and screws.
6. Run the pump through one complete cycle
to verify the correct operation.
personal injury or property damage. Failure
to make this operational check may lead to
improper operation, premature failure and
flooding.
Handle Screws
Handle
Pump
Cover
Figure 1
Cord Lift Warning
3
Risk of flooding. May cause
Cord Align the indents on the
Connector plug and the socket
Cord
Connector
Socket
1-800-468-7867