Alarm Setting - Westfalia WT350 Manual De Usuario

4.2 Alarm clock function:

4.2.1 Alarm setting

 Slide main switch (B8) to
Alarm time of ALM-1 is blinking. Press the "+" or the "-" button (B1 / B3) to set the alarm time of Alarm 1. Press the

"SNOOZE/LIGHT" button to confirm and continue the setting.
Alarm time of ALM-2 is blinking. Press the "+" or the "-" button (B1 / B3) to set the alarm time of Alarm 2. Press the

"SNOOZE/LIGHT" button to confirm and return to the beginning of this setting or slide the main switch (B8) to
confirm the setting and return to normal time display.
Notes:
 At any time, slide main switch (B8) to
Hold the "+" or the "-" button pressed to accelerate the setting process and reach the desired value more quickly.

4.3.2 Alarm alert modes
Alarm could be set to alert in sound "

 The alarm volume could be adjusted to lower volume or louder volume by slide switch (B5) on rear casing.
NOTE: When the alarm mode is set in vibration mode, we suggest to place the unit under the pillow. The unit
might fall off while vibrating if it is placed on surfaces by stand.
4.3.3 Activate/Deactivate alarm and snooze alarm

Slide alarm 1 or alarm 2 on/off slide switch (B6 / B7) to ON to activate alarm 1 or alarm 2 function, alarm icon
" " display.
When alarm alerts or vibrates, icon "

minutes, then it alerts or vibrates again. Snooze Icon "
process can be repeated 7 times.
 Slide alarm on/off slide switch (B6 / B7) to OFF to deactivate alarm function. Otherwise, the alarm signal alerts or
vibrates for about 3 minutes, then stops automatically.
5. Timer/stopwatch
5.1 Timer
Setting of timer
 Slide main switch (B8) to timer to enter to timer function.
Press the "+" or the "-" button to adjust the timer value, and start countdown function by pressing

"SNOOZE/LIGHT" button.
Press "SNOOZE/LIGHT" button again to stop it, and then press the "+" and the "-" button together to reset timer
value to zero.
When timer is counting down, hold the "+" or the "-" button to view the current time, and return to timer display by

releasing "+" or "-" button
NOTE:
 Maximum countdown timer value is 39hours 59 minutes
to enter the setting of alarm time.
to confirm the setting and return to normal time display.
" or vibration "
" flashes, press "SNOOZE/LIGHT" button, alarm snoozes for around 5
" by alarm mode slide switch (B4).
" flashes on the LCD during the snooze time. This
EN3
to