Home Decorators Collection 81160 Guía De Uso Y Cuidado

TOOLS REQUIRED
Phillips
Level Pencil
screwdriver
Installation
1
MOUNTING THE BRACKETS
□ Use the mounting template (A) to
determine the location of the holes for
the mounting brackets (B). Mark the
hole locations on the wall and remove
the template. Use a level to ensure
the hole locations are even. If you are
installing this mirror on a wall without
studs, use a drill bit to drill
17/64"
holes in all four locations. Then place
anchors (C) inside the holes.
□ Place the brackets (B) over the
holes and fasten to the wall tightly
with screws (D) using a Phillips
screwdriver.
B
C
4
SECURING THE MIRROR TO THE WALL
□ To secure the arms (E) to the wall, use the hex wrench (F) to
tighten the set screws (1) on the bottom of the arms.
E
1
Care and Cleaning
□ Use of a glass cleaner such as Windex®, Zep Commercial® Streak-Free Cleaner, or HDX™
Glass Cleaner. Follow application directions on the spray bottle. Use a soft paper towel or
lint free cloth (preferred) and remove the cleaning solution in a gentle circular motion. If
the mirror surface feels "tacky" while cleaning, simply apply more cleaner.
□ Never clean the mirror with a dry paper towel or lint free cloth without cleaning solution.
□ Do not use cleaners which include fragrances, oils, acids, alcohols, bleach, or abrasive
particles.
□ Do not clean with a scouring pad, rough cloth, abrasive paper towel or window scraper.
Use and Care Guide
Pivot Fog Free Mirror
HARDWARE INCLUDED
A - Mounting
Drill with
template
17/64" drill bit
2 ATTACHING THE ARMS TO THE
MIRROR
□ Align each arm (E) as shown. Then
slide them onto the mirror. Using the
hex wrench (F), lightly tighten the set
screws (1).
D
1
F
B - Mounting C - Anchors
brackets x 2 x 4
3
E
5
ADJUSTING THE ANGLE OF THE MIRROR
□ The mirror can pivot up and down as desired. Use the hex
wrench (F) to tighten the set screw (1) on each arm (E) to
hold the mirror in the desired position. To rotate the mirror
to a different angle, loosen the set screws (1) and re-tighten
when you achieve the desired angle.
E
Item #1001-083-707
Model #81160
D - Screws E - Mounting
x 4 arms x 2
HANGING THE MIRROR
□ Lift the assembled mirror onto the
mounting brackets (B). Hook the top
of the arms (E) on the brackets (B)
and rotate down.
□ In the event that the mirror does
adjust the pivot pin (1). Using a
screw driver, loosen the screw (2)
and adjust the sliding pin (1) as
needed, until the arms are aligned.
Then tighten the screw (2).
1
B
2
1
F
WARNING: Handle this mirror with care. Wear
safety glasses and goggles while handling and
installing this mirror.
WARNING:
installing to wall studs, use the dry wall anchors
provided.
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
F - Hex
wrench x 1
E