Installation And Connection - REV Ritter JR0410MR Manual De Instrucciones

LED exterior lamp oval
Instructions for installation and use
PURPOSE
Lamp for wall and ceiling installation on normally flammable surfaces in damp rooms and in protected exterior
areas. For connection to flush-mounted conduits. Protected from splash water.
Not suitable for use in explosive environments!
SAFETY
• Never look directly into the LED light source!
• The emitted light spectrum can contain proportions of blue! Never use if the casing is open, if the cover
of the cable compartment is missing or damaged, or if the protective cover is missing or damaged!
• Adhere to and keep operating instructions!
• Pass operating instructions on to subsequent owners!
• Not intended for use by children!
• Do not operate a damaged lamp!
• Connection only to be carried out by an authorised professional!
• The light source can only be exchanged by the manufacturer!

INSTALLATION AND CONNECTION

Work with power off! Switch off building fuse!
Pay attention to flush-mounted wires when drilling!
Preparation:
Lay flush-mounted power conduit: NJM; min. 1.5mm² to max. 2.5mm²; ø min. 8 to max. 12mm.
Assembly:
• Unscrew the cover
• Cut out one of the pre-punched openings and insert the rubber gasket
• Lead the connection line through the rubber gasket and connect according to image 3
• Screw on the cover
• Mount the product to the wall with fitting screws (image 4)
SET MOTION DETECTORS
See Fig. 4
CLEANING
Work with power off! Switch off building fuse!
Wipe with a damp cloth. Do not use any chemicals!
REPAIR
Do not attempt to repair the product on your own. Repairs are to be performed solely by the manufacturer or its
commissioned service providers!
GB
9