Jiso BOKE Instrucciones De Instalación

Installation Instructions BOKE Driver
__________________________________________________________________________
PUSH DIMMING
- Turn on the driver or turn it into standby mode by pressing the switch for 0.1-1s(Short press).
- Change the brightness level by pressing the switch for 1-5s(Long press).
- If the drivers in push dimming state need to synchronize multiple dimming, first, turn on the AC powerto confirm each driver are
stand by, then long press PUSH switch to boot.
- Maximun number of driver connected to the same push switch is 20.
- It must be taken into account that long distance in cable can make a delay in the signal.
- Push switch with light indicator are not admitted.
- It is possible to connect several push swtich in paralel but ensuring the connection to the driver is unified in one cable.
1-10V REGULATION
1. Please, if you are not sure with the compatibility of the dimmer, carry out the sample or small batch test before the batch
purchase.
2. The number of drives and the length of wire connections are determined by the following factors:
a. Current output capacity of the dimmer.
b. The interface of the driver consumes current, this product is less than 1mA.
c. The size of the connection wire, and is recommended to use less than 20AWG;
d. Install environmental interference, avoid wiring with high voltage or interference source. If you can't avoid it, you can
consider using shield wire.
3. It is recommended that the number of drives and the dimming connection length are: ≤16 PCS, ≤20m.
4. It is recommended to use a dimmer with active, isolated and strong output current capacity. This product cannot use a non-
isolation dimmer.
5. This product is compatible with various active or passive dimmers. If a few dimmers are not compatible, it is a normal case and
can be contacted us for confirmation.
Installation Instructions BOKE Driver
__________________________________________________________________________
DALI
DALI protocol comprises 16 groups and 64 addresses.
DALI INPUT MIN
High level 9.5V
Low level -6.5V
Warnings
- Please, read and keep, in safe place, the installation instructions before starting the installation af the product.
- Cut the main power supply before starting the installation works.
- NEVER energize the driver without connecting the luminaire before.
- If the luminaire connections are damaged, the replacement must be done by JISO ILUMINACIÓN, SL. or by an authorized electrican
with the aproval of JISO ILUMINACIÓN, SL.
- The installation must be carried out by qualified personnel.
- Improper handling of the components or the luminaire itself could damage the correct functioning of this product, thus voiding
the manufacturer's warranty.
- Driver suitable only to be used indoor.
- DO NOT place the driver or converter over the luminaire (except in surface luminaires of 263/264 or 249 series).
- JISO ILUMINACIÓN is not responsible for the improper use or modifications made to the product.
- The driver must not be covered by insulating material or similar under any circumstances.
- DO NOT use aggressive material (solvent type or similar) to clean the luminaire. The surface may be damaged.
- The driver is designed to be used, only, connected to a stable power supply network. 220-240 ~ 50 / 60Hz.
JISO ILUMINACIÓN, S.L. reserves the right to make technical, formal and dimensional modifications at any time and without prior
notice. It is not allow to reproduce totally or parcially this document without authorization from JISO ILUMINACIÓN, SL.
JISO ILUMINACIÓN assumes no responsibility for any errors that may appear in this document.
Check updated information in website:
www.jisoiluminacion.com
TYP MAX
16V 22.5V
0V 6.5V