Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-348
TIGHTENER/CUTTER
Use in combination with poly strapping and buckles only.
Fits strapping widths 3/8, 1/2 and 5/8"
APPLY TENSION TO POLY STRAPPING
1. Thread the poly strapping through both tightener
grips and squeeze the handles to grip strapping.
(See Figure 1)
Figure 1
2. Pull the Tightener/Cutter until poly strapping is
tensioned as needed. If necessary, hold down
opposite side of strapping with gloved hand to
prevent slipping. (See Figure 2)
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
TRIM EXCESS STRAPPING
1. Place strapping in trimming slot. (See Figure 3)
2. Squeeze handles to cut strapping.
SAFETY RULES
1. Always wear safety glasses with side shields to
2. Always wear protective gloves when handling strap
3. Maintain proper footing and balance when
4. DO NOT use this tool if you are not trained in its use.
5. Keep work areas uncluttered and well lit.
Pour le français, consulter la page 3.
Figure 3
Read instructions carefully. Failure to follow
these instructions can result in severe personal
injury.
prevent severe eye injury or blindness. Safety
glasses should conform to ANSI Standard Z87.1
or EN 166.
or sharp parts.
operating the tool.
Para Español, vea página 2.
0421 IH-348

Publicidad

loading

Resumen de contenidos para Uline H-348

  • Página 1 Para Español, vea página 2. Pour le français, consulter la page 3. H-348 1-800-295-5510 uline.com TIGHTENER/CUTTER Use in combination with poly strapping and buckles only. Fits strapping widths 3/8, 1/2 and 5/8" INSTRUCTIONS APPLY TENSION TO POLY STRAPPING TRIM EXCESS STRAPPING 1.
  • Página 2 H-348 800-295-5510 uline.mx TENSIONADORA/ CORTADORA Utilice en combinación con fleje de polipropileno y hebillas solamente. Se adapta a anchos de fleje de 1, 1.3, y 1.6 cm (3/8, 1/2 y 5/8") INSTRUCCIONES TENSIONE EL FLEJE DE POLIPROPILENO RECORTE EL EXCESO DE FLEJE 1.
  • Página 3 H-348 1-800-295-5510 uline.ca SERTISSEUR/ COUTEAU Utiliser uniquement en combinaison avec les feuillards et boucles. Convient aux largeurs de feuillards de 1, 1.3 et 1.6 cm (3/8, 1/2 et 5/8 po) INSTRUCTIONS APPLIQUER DE LA TENSION AU FEUILLARD EN POLY COUPER LE FEUILLARD EN TROP 1.