Getting Started; Installing The Batteries; Low Battery Warning - STACK-ON PC-1702-RFID Manual De Instrucciones

GETTING STARTED

When you first receive your case you will need
to open the cover with the key in order to install
the batteries. Batteries are included and are
located inside the case.
NOTE: The key has also been provided if you lose
or forget your security code or the batteries run
low. If you lose your key, or any of your RFID
devices, you may purchase a replacement by
referencing the serial number located on the
back of the case. See section regarding
replacement RFID device/keys for further
information.
To open the case, insert key into the lock and
turn clockwise until the cover automatically
opens.
NOTE: You must turn the key back to the
locked position before you are able to close
and lock the cover.
REMOVE KEY
OPEN

INSTALLING THE BATTERIES

NOTE: Do not mix old and new batteries. Do
not mix alkaline, standard or rechargeable
batteries.
Pull the foam upward and away from the
battery compartment. Remove the battery
compartment by pushing the tab and pulling the
compartment out as shown. Install (4) AAA
alkaline batteries which are included. Reinstall
the compartment by hooking the back end in
place and snapping shut. CAUTION: Be careful
not to pinch any wires while reinstalling the
battery compartment.
Red light will flash and beep once (if the sound
is turned on) if batteries are installed correctly.

LOW BATTERY WARNING

NOTE: If the batteries are low the lights will flash
red when the buttons are pushed. Replace the
4 AAA batteries with new alkaline batteries as
described above.
OPEN
4 - AAA
batteries
Battery Carriage
40720-1704
2
16