Technical Data; Assembly And Operation - Worx 20V MAX LITHIUM Instrucciones De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. HANDLE
2. ON /OFF SWITCH
3. BATTERY PACK*
4. DUST BRUSH
5. SHORT TUBE
6. BATTERY PACK RELEASE BUTTON*(See Fig. B)
* Not all the accessories illustrated or
described are included in standard delivery.

TECHNICAL DATA

Rated Voltage
No load speed
Blow speed
Air volume
Charging time
Machine weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
ACCESSORIES
Battery pack
1 (WA3520)
Charger
1 (WA3742)
Short Tube
Dust Brush
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose
the type according to the work you intend to
undertake. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
Workshop Blower
WX093L
WX093L.9
20V
Max**
12500/min
110mph
64cfm
5hr
/
3.5 lbs
2.7 lbs
WX093L
WX093L.9
/
/
1
1
1
1

ASSEMBLY AND OPERATION

Action
Installing & Removing the
Battery Pack (WX093L)
NOTE: Depress the Battery Release
Button to release battery pack from
your tool. After recharging, insert the
battery pack into tool's battery port.
A simple push and slight pressure
will be sufficient.
Charging the battery (WX093L)
More details can be found in
WA3742's manual
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices.
Never insert or allow metallic objects
into your charger or battery pack
connections because of an electrical
failure and hazard will occur.
BEFORE USING YOUR CORDLESS
BLOWER
Your battery pack is UNCHARGED,
you must charge before use.
Starting & Stopping
WARNING! The tool runs for a
few seconds after it has been
switched off. Let the motor come to
a complete standstill before setting
the tool down.
Assembling the Short Tube
Using the Short Tube
Removing the Short Tube
Assembling the Dust Brush
Using the Dust Brush
Note: The Dust Brush is used for
brushing smaller areas like car
interiors, keyboards.
Removing the Dust Brush
CLEANING THE TOOL
Clean the tool regularly.
WARNING! Keep your product dry.
Under no circumstances spray with water.
—To clean the tool, use only mild soap and a damp
cloth.
—Do not use any type of detergent, cleaner or
solvent which may contain chemicals that could
seriously damage the plastic.
—Self lubricating bearings are used in your product,
therefore lubrication is not required.
Figure
See Fig. A
See Fig. B
See Fig. C
9
See Fig. D1
See Fig. D2
See Fig. D3
See Fig. E1
See Fig. E2
See Fig. E3
EN

Publicidad

Tabla de contenido
loading

Productos relacionados para Worx 20V MAX LITHIUM

Este manual también es adecuado para:

Wx093lWx093l.9

Tabla de contenido