Eneo VHM/H24W Instrucciones De Montaje página 8

3.1.1 Configuration of the factory-installed 24V heating for 12V operation
left
Voltage
24V (factory)
12V configuration
3.2 Assembling the 230V heater kit VHM/H220
S
F The heater is screwed directly into the front section F of the housing. Then, remove the front
section from the housing by loosening the two 4mm Allen wrench screws.
H,g The heating element H is attached at the designated place using 3x6mm self-tapping
crosshead screws g.
S A duct S is provided inside the housing profile for running the connection cable to the screw
terminal.
Solder bridges A
A open on both sides
(right/left)
A closed on both sides
(right/left)
g
right
Solder bridges B
B closed on both sides
(right/left)
B open on both sides
(right/left)
(Art. No. 71301)
H
A
B
C
Solder bridges C
C open on both sides
(right/left)
C closed on both sides
(right/left)
F