Starting + Stopping - Sun joe 24V-SSEG-CT Manual Del Operador

Fig. 8
4. To remove the blades, gently press the latches on both
sides and lift the blades up (Fig. 7).
NOTE: If you have any questions, please call the Snow Joe
Sun Joe customer service department at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
Operation
IMPORTANT! The product is intended for light-duty trimming
of shrubs for residential properties.
m
WARNING!
The blades continue to move for a few
seconds after the tool is switched OFF. Turn OFF the tool and
wait until the blades come to a complete stop before adjusting
or cleaning.
m
CAUTION!
Never touch the blade or blade rail while
the tool is in operation and be aware of the sharp edges even
when the hedge trimmer is not in use.
TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY
In order to operate this cordless hedge trimmer you will need
an iON+ 24V System battery and charger. See page 14 for
battery and charger options and specifications, or for more
information visit sunjoe.com.

Starting + Stopping

1. Insert the battery fully in the battery compartment (Fig. 9).
Fig. 9
Battery
Battery
compartment
2. To power ON, push and hold the safety lock button with
your thumb, while pressing the ON/OFF trigger switch
with your forefinger. Once the trigger switch engages,
you can release the safety lock button and proceed with
operation (Fig. 10).
Fig. 10
+
®
NOTE: The safety lock button reduces the risk of accidental
starting.
3. To power OFF, simply release the ON/OFF trigger switch
(Fig. 10).
m
CAUTION!
Do not force the blades through dense
growth. If the blades slow down, then reduce your cutting
pace. Should the blades jam, release the trigger immediately.
Do not use your fingers to free up jammed blades. Jammed
blades can release suddenly causing serious injury.
m
CAUTION!
Always ensure proper footing and balance
in a clean and clear work environment before switching on the
cordless hedge trimmer.
Trimming Tips
NOTE: Try to keep the cutting device angled at approximately
15° to the cutting surface (Fig. 11).
Fig. 11
11
Safety lock button
ON/OFF
trigger switch
15°