Eiko WPT-1C-U Instrucciones De Instalación

SAFETY PRECAUTIONS:
IMPORTANT: READ CAREFULLY BEFORE INSTALLING THE FIXTURE. RETAIN FOR FUTURE REFERENCE.
GENERAL: Upon receipt of the fixture, thoroughly inspect for any freight damage which should be brought to the atten-
tion of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the housing
to assure you have received the correct item.
SAFETY: This fixture must be wired in accordance with the international electrical code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe the correct grounding procedure.
WARNING: Risk of fire and shock. If not qualified, consult an electrician. Disconnect power at the circuit breaker panel or
fuse box before installation or service.
INSTALLATION:
1. Open the fixture by loosening the two tamper-proof screws on the side. Disconnect the LED module power leads from
the LED driver and remove the LED assembly. Do not drop or mishandle the LED assembly.
2. Prepare the back plate for mounting by drilling or knocking out the appropriate holes. ( See Fig. 2 ). Remove the LED
driver module from the back plate if necessary.
3. Line up the back plate in desired location and mount securely. Two gaskets are provided for a weather-tight seal be-
tween the template and the junction box.
4. If using electrical conduit, remove the screw cap from the desired conduit hole and replace with conduit. Route the
branch circuit wires inside the fixture. If using a junction box, bring the branch circuit wires through the rear hole into
the fixture.
5. Reattach the LED driver module to the back plate.
6. Splice the branch circuit power leads to the fixture power leads, black to black (hot), white to white (neutral), and green
to green (ground).
7. Reattach the LED module power leads to the driver and replace the LED assembly using the provided tamper-proof
screws.
MOUNTING:
The back plate has a cast-in drill and knock-out template to match any standard recessed junction box, three 5/16"
knockouts for mounting holes A and three 1/2" NPS tapped holes D for surface conduit or photocontrol unit.
A – 5/16" dia. Knockouts
B – 9/16" dia. Knockouts.
IMPORTANT:
To weather-proof your outdoor installation, use silicone sealant to seal all holes in the fixture housing (mounting, conduit,
plugs, photocontrols, etc.) and all edges between the fixture housing and the mounting surface.
NOTE: Driver is designed for 120-277 VAC without any change in wiring.
TROUBLESHOOTING CHECKLIST: If the light does not work:
-- Check your power source.
INSTALLATION INSTRUCTIONS
C – Knockouts for #10 screw.
D – 1/2" NPS tapped holes.
-- Check electrical connections.
WPT-1C-U & WPT-2C-U
LED Wallpack Trapezoid