Horizon Global 65080 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
①
②
Fasteners typical
both sides
Figure 1
NOTE: If present, remove front skid shield and enlarge the hole shown in Figure 2 to allow for oil filter access. Reinstall
trimmed skid shield.
1. Remove Tow Hooks– Using a 17mm socket, remove (2) M12 bolts remove the tow hook and set aside for reinstallation later. Repeat for other side.
2. Raise hitch into position – Install with tow hooks if present, install M12 bolts and conical washers (teeth side toward hitch) 2 each per side.
3. Torque M12 hardware to 42 ft*lb (57 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been
damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2018 Horizon Global Americas Inc. -
Installation Instructions
PART NUMBERS: 65080, CQT65080
Frame rail
Printed in Mexico
SKID SHIELD TRIM DIAGRAM
Tow Hook
DRIVER SIDE
Sheet 3 of 9
Fastener Kit: 65080F
① Qty.(4) Bolt M12x1.25x55mm
Cl8.8
② Qty. (4) Conical Tooth
Washer 1/2"
Part no. 01292008
Conical Washer
Against hitch
PASSENGER SIDE
Figure 2
65080N 05-14-18
Teeth side
Rev. A