Mounting - jcm-tech PUSH Manual Del Instalador

3 Mounting

UM_3201064_PUSH_EN_Rev00
1. Identify a suitable location on wall or flat
surface.
2. Stick the Drilling Template and drill 3
holes as indicated in the diagram.
3. Insert 3 nos. of 5 mm wall plugs provided
into the drilled holes.
4. Route the cables through the holes
provided in the BackPlate.
5. Fix the Backplate firmly on the wall using
3nos. of 3x30mm CSK screws
6. Connect wires and place the housing
over the fixed backplate, guide the slot into
the backplate tab and slide it downwards.
7. Fix the Housing to the Back-Plate with
the M3x6 mm Security Screw using a
Security Screwdriver provided.
Important Note:
protection are provided against transient
voltages from static discharge, lightning and
sparks. For protection to be fully effective,
earthing should be done correctly.
Several layers of
5/8