Tripp-Lite NPOE-EXT-1G30WP El Manual Del Propietario página 3

RJ45 Cable Wire and Crimp Steps
1. Strip an inch or so of the outer skin of a Cat5e/6 cable with a utility
knife. Separate and straighten the internal wires, and arrange them in
the proper order. Use a wire cutter to trim the wires evenly. Slide one of
the included water-resistant covers along the end of the cable.
2. Insert the neatly trimmed wires into an RJ45 modular connector plug
(such as Tripp Lite's N230-100) in the correct order. Use your crimping
tool (such as Tripp Lite's T100-001-TST) to press the cable jacket and
the wires into the RJ45 connector. Be sure to test the connection to
ensure the cable is working properly.
3