Axis Videolarm 24889 Instrucciones De Producto

Axis Videolarm 24889 Instrucciones De Producto

Publicidad

Enlaces rápidos

f
or
C O M M U N I C A T I O N S
PRODUCT INSTRUCTIONS
MODEL:
24889, 29892
Before attempting to connect or operate this product,
81-IN6209R1
please read these instructions completely.

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Axis Videolarm 24889

  • Página 1 C O M M U N I C A T I O N S PRODUCT INSTRUCTIONS MODEL: 24889, 29892 Before attempting to connect or operate this product, 81-IN6209R1 please read these instructions completely.
  • Página 2: Important Safeguards

    TECHNICAL SUPPORT If technical support is needed, Axis has set-up a technical support In the event of a breach of the above warranty, Axis shall, line for their customers. at its option, repair or replace said product. This is Axis's sole obligation under this warranty.
  • Página 3: Electrical Specifications

    Electrical Specifications Unpacking the Product 24889 Input Power: 24 VAC Power Consumption: 1.45Amp Total Consumption Power Output: 27 Watts Heater/Blower Up to 8 Watts Camera Power Tools Required: Phillips Screwdriver 7/16 Wrench or Socket 24VAC 50Watts Wire Gauge Distance Energía De Entrada: 24 VAC De Consumo De Energía: 1.45Amp Total Consumption...
  • Página 4 Attach the bracket to the wall and secure Remove the tilt mechanism from the bracket. appropriately. Una el soporte a la pared y asegúrelo apropia- Quite el mecanismo de la inclinación del • • soporte. damente. Attachez la parenthèse au mur et la fixez conve- Enlevez le mécanisme d'inclinaison de la •...
  • Página 5: Rear Panel

    REAR PANEL External Microphone/ Line Input Audio Output DC-Iris Control Cable Sled Screw Network Terminal Connector Power Connector Camera Sled and PoE Connector Place camera on sled and align mounting holes on Feed the wiring through the conduit plugs and make each.
  • Página 6 Adjust Lens Here If desired, use the security screws in place of hex Adjust the focus and focal length until the desired field of view and focus is obtained. For the 29892 wireless, attach the antenna screws. lead to the camera. •...
  • Página 7 (For Wireless Unit 29892) Align to fit grove Slide Sunshield over first grove of housing Connect antenna to antenna plug. top. • Resbale arboleda del excedente de Sunshield la • Conecte la antena con el enchufe de antena. primera de la tapa de la cubierta. •...
  • Página 8: Replacement Parts List

    (For Wireless Unit 29892) Hole GROVE Rear View Press down evenly on sun shield, the sun shield Align holes and secure with bolt and nut. will snap into position on top set of groves • Apriete uniformemente en el protector del sol, el protector del sol se •...

Este manual también es adecuado para:

Videolarm 29892

Tabla de contenido