Nexxt Solutions Corregido V2 Guia Del Usuario página 7

1. Shut power off at the breaker
Find the breaker that controls the circuit for the junction
box where the oodlight will be installed. Turn it o before
you continue installation.
Place tape over the circuit breaker switch and verify power
is o at the light.
Note: you can use the circuit tester at this point to verity
that power is cut o .
2. Determine the location
With the power o at the breaker, carefully remove any
existing light xture from the junction box.
Make sure to label the wires (ground, line or phase and
neutral) from existing xture prior to removing.
Existing oodlight
Note: If there wasn't a light xture previously installed,
then professional wiring installation will be required prior
to proceeding to the next step. Seek technical help in this
case.
3. Prepare your floodlight camera for installation
• Loosen the knobs on the light xtures to rotate them out
of the way and allow access to the mounting screws.
• Rotate the camera to adjust the viewing angle in the
desired direction.