Publicidad
Idiomas disponibles
Idiomas disponibles
4)
Insert the elements in the post beginning from the plate cover, going on with spacers and steps and
finishing with the landing.
5)
Position the landing step according to the opening. In the case of wooden floor/slab use only screws for
wood, of the hanger bolt/leg bolt type, to replace those provided exclusively suited to reinforced concrete.
6)
Insert the terminal flange, the threaded bar and the terminal in the pole, then tighten using the nut, in
order to compress the staircase, but leaving the steps free to rotate.
7)
Put together the pipe fitting "Novia" assembling the elements. For the assembly of plastic components
of the railing always use the lubricating grease.
8)
Insert balusters in all steps, doweling the ones that go through the step and locking the other ones with
the expansion bushing "Espa". Lock well the plastic insert in the outer bush of plastic, before inserting it in
the baluster. be careful not to overtighten the screw. check it before inserting the column into the hole Do
not fully tighten all the fixing dowels of the passing balusters before having compacted the whole stair.
Finish the definitive tightening only after having completely screwed the threaded rod with a M22 nut.
9)
The first baluster of the stair need to be cut and secured to the floor with pipe fitting "Bicchierino".
In the case of wooden floor/slab use only screws for wood, of the hanger bolt/leg bolt type, to replace
those provided exclusively suited to reinforced concrete.
10)
Balusters adjustement
Before baluster's tightening it is necessary to adjust the slope according to the risers.
11)
This draw shows the assemblying of "Safety‐riser" for model Gamia Wood. The same instructions are
for model Gamia Metal. If the safety riser baluster is too long, you need to resize it to measure
12)
Having completed the staircase assembly, apply the supplied adhesive non‐slippery strips
13)
Assembling of landing balustrade
For the platform railing, in correspondence of the passing hole use the baluster 1165 mm long that is
specially provided in the kit, to be cut to size. Fix the provided baluster‐floor fixing element to block the last
passing baluster on the landing platform (on the opposite side of the platform railing) or the last baluster of
the platform railing.
The handrail of the stair must be fixed first to the passing balusters and secondly to the central balusters of
the step.
14)
Balusters assembling
‐ Assemble the balusters (Ht. 925 mm, 36 3/8") connecting the bushing "Espa" and screwing the fitting
‐ Mark out the floor the central position of the balusters for the balustrade, note also that a distance of
about 50 mm (2") from the opening is needed and that the axle base among the balusters can't be over 120
mm (4 1/2")
‐ Drill holes with a Ø 12 mm (1/2"'94) bit and insert the nylon expanders.
‐In the case of wooden floor/slab use only screws for wood, of the hanger bolt / leg bolt type, to replace
those provided exclusively suited to reinforced concrete.
"2012©Rintal S.p.a–Tutti i diritti riservati-All rights reserved"
4
FM_GAMIA-METAL_R6
Publicidad
