Uline H-1669 Manual Del Usuario página 2

Figure 1
23⁄"
MOUNT BED AND CHASSIS
1. Screw two of the mounting screws into the pilot holes
leaving 1/4" exposed to allow keyhole slots to be
easily mounted over the screw heads. (See Figure 2)
2. Place chassis over screws as shown in illustration.
3. After securing the unit using the keyhole slots, verify
that the unit is level.
4. Tighten top two screws so that they are flush with the wall.
5. Use the four lower holes as a guide to mark and drill
pilot holes.
6. Use remaining four screws and four washers to
complete installation of bed and mounting bracket.
Insert washers over lower four screws.
IMPORTANT! All six screws and four washers
provided must be mounted to the chassis to
ensure proper load bearing capacity.
Figure 2
PAGE 2 OF 9
INSTALLATION CONTINUED
9⁄"
9⁄"
INSTALL LINER DISPENSER
Ensure liner dispenser is free from damage. Remove key,
unlock and open liner dispenser lid. This will expose liner
dispenser mounting holes. Line up dispenser mounting
holes onto chassis and secure with the four 8/32 x 5/16"
screws provided. Close and lock the liner dispenser lid.
(See Figure 3)
Figure 3
16"
Top two screws at 42⁄"
to meet ADA Height
Requirements
Floor
0721 IH-1669