Sears Kenmore 580.76129 Manual Del Propietário página 7

_r_ Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
_gud_ ITEM E
LOWerguide •. *
INDOOR DOOR FIG. 10
_1 Place the sill supports with the cabinet on the
window sill's selected position.
_i] The cabinet should be installed with a very
slight tilt (about 1/4") downward toward the outside
(FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
,<
ITEM B FIG. 11
_11 Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the front angle into the
window inner sill (FIG. 12).
Track
ITEM B
ITEM F
FIG. 12
[_ Pull each side curtain fully to each side of
window opening.
Attach each side curtain 1o the window sash using
screws (ITEM G). (FIG. 13)
ITEM G
FIG. 13
_'] Attach the L BRACKET (ITEM J) with screw
(ITEM G). (FIG. 14)
ITE_
FIG. 14
_] DRAINAGE
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
downward 1othe outside for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe. (FIG. 15)
_]-_ BASE PAN REAR
DRAIN_.I_
_OM FIG. 15
B Slide the chassis into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side
screws you removed in step 1.
Cord
-7-
Screw
Screw FIG. 16
I_Cut the foam strip (ITEM H) to the proper length
and insert between the upper window sash and the
lower window sash. (FIG. 17)
FIG. 17
_'_ The vent control handle must be straightened
before the decorative front is attached.
Pull out part ® to align with part _).
FIG, 18