Acoem OneProd Eagle Manual Del Usuario página 8

8
3. G
ATEWAY
3.1. I
DENTIFICATION
3.2. I
NSTALLATION
During installation or disassembly of EAGLE devices, the operator must wear the prescribed
PPE (Personal Protective Equipment), respect the regulations in force and have the necessary
clearances operation.
3.3. O
PERATING ENVIRONMENT FOR GATEWAY
EAGLE devices are designed to operate in normal environmental conditions as described in
standard IEC60950:






3.4. H
AZARDOUS ENVIRONMENTS

3.5. C
ONNECTIONS
In zone 2 hazardous environments, before connecting or disconnecting the Ethernet cable to
the gateway, always ensure the following:

The Ethernet cable must not be connected to the other end.

The operator has to prevent the occurrence of an ignitable atmosphere (using suitable
gas detection systems).

Do not exceed maximum input voltage and current on the Ethernet connector:
 Maximum input voltage is 48 V DC – 0.3 A
3.6. S
TORAGE
The storage area should be clean, cool (not exceeding +25°C [+77°F]), dry and ventilated.
Do not leave EAGLE devices exposed to a heat source or high temperature location such as
an unattended vehicle. To prevent damage, remove the devices from the vehicle.
Table 4: Gateways part numbers
Model Device
EGL1101000 Gateway with embedded antenna
/
DISASSEMBLY FOR GATEWAY
Altitude up to 2,000 m [6,500 ft]
Temperature ranging from -20°C to +60°C [-4°F/+140°F] (non hazardous
environments)
Pollution rating 2 (only non-conductive pollution occurs except that occasionally
a temporary conductivity caused by condensation is to be expected.)
< 95% non-condensing relative humidity
Indoor & outdoor use for EGL1101000 (internal antenna)
(Pending)
Brand of ACOEM