Uline Fellowes PS-79Ci Manual Del Usuario página 4

OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and
could ultimately stop running. To avoid these problems,
we recommend oiling shredder each time user empties
waste bin.
CAUTION! Use only a non-aerosol vegetable oil
in long nozzle container, such as S-16094.
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are for maintenance-free
operation. However, on rare occasions the sensors may
become blocked by paper dust, causing the motor to
run even when there is no paper present.
1. Turn off and
unplug shredder.
OPERATING ISSUE
Overheat Indicator
Bin Open
Bin Full
PAGE 4 OF 15
2. Locate auto-start
infrared sensor.
TROUBLESHOOTING
When the Overheat Indicator is illuminated:
1. Allow the shredder to cool down.
2. Resume shredding once the Overheat Indicator is no longer
illuminated.
When Bin Open is illuminated:
1. Close the bin.
2. Resume shredding.
When Bin Full is illuminated:
1. Empty the bin.
2. Resume shredding.
MAINTENANCE
Follow oiling procedures below and repeat twice.
1. Apply oil
across entry.
NOTE: Two paper detection sensors are located
in the center of the paper entry.
3. Dip cotton swab
in rubbing alcohol.
RECOMMENDATIONS
2. Press and hold forward (
for 2-3 seconds.
4. Using cotton swab, wipe away any
contamination from the paper sensors.
)
0521 IH-2606