Routine Care - BOND MANUFACTURING HYMH20027-3 Manual Del Usuario

STEP 4. LEAK TEST
Perform leak test in a well ventilated area outside and where no source of spark can occur.
Connect cylinder to regulator. Turn the on/off valve at the unit to the 'off' position to pressurize the control system.
Use a soapy water solution to check all the connections leaks before attempting to light the appliance. If a leak is
found or you smell gas, disconnect cylinder and turn valve off and do not use the appliance until repairs can be
made.
TIPS:
Before Beginning ●Read the instructions thoroughly.
TO LIGHT
Before each use, inspect all parts.
*After assembling the gas tank, push and turn the Control Knob counter-clockwise, then use a match or a
lighter to light the fireblow. To adjust the flame, turn the Control Knob. Push and turn the Control Knob
clockwise to turn the flame off.
TO EXTINGUISH
※ Push the Control Knob and turn clockwise to the "OFF" position.
※ Disconnect propane cylinder to close the gas supply if not for use in a long time.

ROUTINE CARE

※ Keep your firebowl free and clear from combustible materials.
※ Visually inspect burner from obstructions, keep tank enclosure free and clear from debris.
※ After the burner and lava rocks are completely cooled down, use a soft brush to get rid of the mild stains,
loose dirt and soil. Wipe with a soft cloth.
STUBBORN STAINS
※Stubborn stains,discoloration and possibly rust pitting can occur from exposure to
harsh outdoor conditions。
Be careful not let any powder or solvent come in contact with painted or plastic components as damage may
※
occur. occur
●Check and make sure that all parts are present.
●For future reference, save this owner's manual.
7