Has the appliance
stopped working?
Technical data.
● The plug is properly plugged into the wall
socket.
● The fuse is intact.
● The power has not been cut off.
● All controls are correctly set.
● Do not open the cabinet unnecessaryly.
Before calling a repairman, check that
● Switch off the cabinet for 15 minutes (for
instance at the thermostat). Switch it on
again and after 5 minutes check whether
frost has formed on the evaporator.
This device complies with relevant EU
directives including Low Voltage Directive
2006/95 EEC. and Electromagnetic Com-
patibility Directive 2004/108/EC
The rating plate provides various techni-
cal information as well as type and serial
number.
Installation.
See drawings - page A - C.
Install the cabinet in a dry place and so that
other sour ce of heat.
feet at the front edge of the base.
its hinged side. When placing the cabinet
If you want to build the appliance into a
work satisfactorily.
2. When the door is opened the appliance
side.
3. The distance to the wall at the hinge side
.
it is not exposed to direct sunlight or any
two appeliance. If one of these is a wine
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
It is safest to place the earthed wall socket
The cabinet may not rest against a wall on
on a carpet or on a wooden floor you should
adjust it once more after some time as the
cabinet might settle in soft foundati ons.
5
cupboard you must consider 3 factors:
1. There must be space above the appli-
ance in order to make the cooling system
takes up more room in the width and
therefore the door must either be placed
outside the cupboard or there must be
a space of at least 1,5 cm at the hinge
must be of a sufficient size.
Furthermore it is possible to build together
cabinet please observe a min. distance of
25mm between the cabinet in order to keep
cooling performance intact.
abo ve the appliance and at least 2.0 m
above the floor. Any local installation rules
for appliances of this kind must be ob-
served.
GB