Remote Control - Hortensus HOR-LEDTAB Manual Del Propietário

Introduction
Read this guide carefully and keep it for future reference.
Hortensus disclaims any responsibility for the defective caused by incorrect use of the product.
For any questions, please contact info@hortensus.eu.
Want to see more garden products? Visit our webshop: www.hortensus.eu
Specifications:
Power consumption: < 10W
Input: AC 100V/240V 50/60 Hz
Output: DC 5V 1500mAh
Battery type: Lithium
Charging time: 4-6 hours
Working time: 6-12 hours
Instructions
1. Remove the orange charger seal to plug input for charging. Charge for 6 hours for a first
use.
2. After charging, cover the DC input with the charger seal and it is securely fasted to prevent
water seepage.
3. To turn on, press the switch, this will start the last mode which was previously selected.
4. To turn off, press the switch for a few seconds
5. The adapter's indicator light is red when the lamp is charging, it turns green when the
battery is fully charged.
Charger
Do not use the charger near a heat source
Do not touch the charger while charging, disconnect the charger after charging
Do not try to open the charger.
Don't use the charger outdoors as it is not waterproof

Remote control

Quick select colours
(16 col)
Speed/brightness Turn ON/OFF
Flash
Strobe
Fade
Smooth
EN