Publicidad
ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE MONTAJE
CAUTION:
1. READ THIS INSTRUCTION MANUAL BEFORE YOU
ASSEMBLE SET.
2. ASSEMBLE ON SOFT SURFACE TO PREVENT DAMAGE TO
FINISH OF PRODUCT.
PRECAUCIÓN:
1. LEA ESTE MANUAL DE INSTRUCCIONES ANTES DE
ARMAR SET.
2. ARME ESTE PRODUCTO EN UNA SUPERFICIE SUAVE PARA
EVITAR DAÑOS AL ACABADO DEL MISMO.
ASSEMBLY TOOL REQUIRED
PHILIPS SCREWDRIVER.
HERRAMIENTAS REQUERIDAS: DESTORNILLADOR PHILIPS.
STEP 1
1.1 PLACE TOP PANEL (A) FACE DOWN ON SOFT CLOTH IN
ORDER TO PROTECT SURFACE. SCREW SIDE BARS (E, D)
INTO TOP PANEL (A), THEN INSERT CROSS BARS (H)
BETWEEN SIDE BARS (D, E) AS SHOWN.
1.2 TAKE SIDE BARS (F, G) THROUGH MIDDLE PANEL (B),
SCREW INTO SIDE BARS (E, D) OF 1.1 FINISHED, THEN INSERT
CROSS BARS (H) BETWEEN SIDE BARS (F, G) AS SHOWN.
1.3 TAKE SIDE BARS (F) THROUGH MIDDLE PANEL (B), SCREW
INTO SIDE BARS (F, G), THEN INSERT CROSS BARS (H)
BETWEEN SIDE BARS (F) AS SHOWN.
1.4 ATTACH BOTTOM PANEL (C) ONTO 1.3 FINISHED USING
FEET (I) AS SHOWN.
PASO 1
1.1 COLOQUE EL PANEL SUPERIOR BOA ARRIBA EN UNA
SUPERFICIE SUAVE PARA EVITAR DAÑOS A LA SUPERFICIE.
ATORNILLE BARRAS LATERALES (E,D) AL PANEL SUPERIOR (A),
LUEGO INSERTE LOS TRAVESAÑOS (H) ENTRE LAS BARRAS
LATERALES (D, E) COMO SE MUESTRA.
3
Publicidad
