Installation - Tripp-Lite SRCOOLNET2 Guía De Instalación E Inicio Rápido

Installation

The SRCOOLNET2 allows the user to communicate with and control Tripp Lite's
SRCOOL7KRM and SRCOOL18K spot coolers as manageable devices on a network
accessible via Web Browser, Network Management Station or Telnet.
1 - Preparation
Confirm Package Contents: In addition to this manual, your package should
1-1
include the following:
• Configuration cable (73-1025)
• ENVIROSENSE Module
• ENVIROSENSE User Manual
Locate MAC Address: The 12-digit MAC address (000667xxxxxx) is located on
1-2
the SRCOOLNET2.
2 – Installation
2-1
Insert the SRCOOLNET2 into the front SNMP accessory slot on the
SRCOOL7KRM or SRCOOL18K (Figure 1 in section
2-2
Connect SRCOOLNET2 to Network: Connect a standard Ethernet patch cable
to the RJ45 Ethernet port on the SRCOOLNET2. Note: This port does not
support PoE (Power over Ethernet) applications.
Determine Network Installation Method: If your network's DHCP server will
2-3
assign a dynamic IP address to the SRCOOLNET2 automatically, proceed to
3 - Dynamic IP Address Assignment. If you will assign a static IP address to
the SRCOOLNET2 manually, proceed to 4 - Static IP Address Assignment. If
you are uncertain which method to use, contact your network administrator for
assistance before continuing the installation process.
15-02-247-93342E.indb 2
4-2 ).
2
4/9/2015 9:52:07 AM