Cleaning Instructions - Ragalta RCF-600 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
1. Place the bottom of the Motor Housing into the top of the Base or Clip, aligning the holes in
the bottom of the Housing with the holes in the Base or Clip.
2. Insert the Tilt Adjustment Knob through the holes and tighten the Bolt on the end of the
Knob.
OPERATING INSTRUCTIONS
1. Ensure the slide switch is at "OFF" position.
2. Plug the unit into a standard 120Vac 60Hz electrical outlet.
3. If Clip fan is in use, attach the Clip to a flat, level, steady and stable surface.
4. To turn the fan on, slide the Power Switch to the desired fan speed setting: "LO" or "HI".
5. To turn the fan off, slide the Power Switch to the "OFF" position.
6. To adjust the fan tilt:
a. Loosen the Tilt Adjustment Knob.
b. Adjust the fan to the desired angle.
c. Securely tighten the Tilt Adjustment Knob.
7. Unplug the product from the electrical outlet when it is not in use or is left unattended.
WARNING: To avoid the risk of electrical shock, always make sure the product is
unplugged from the electrical outlet before disassembling, cleaning, servicing or
relocating.

CLEANING INSTRUCTIONS

3